3RACING BS-XN1/V1 Ball Bearing Set for XRAY NT1 Race Use  [BS-XN1/V1]

Refine your XRAY NT1 with precision bearings

The 3RACING BS-XN1/V1 bearing set is built for the XRAY NT1 chassis and offers a clean, low-friction swap for worn components. These bearings help the drivetrain spin more freely and support predictable throttle response on varied surfaces.

The benefit of replacing bearings

New bearings lower rolling resistance and reduce heat build up in driveline parts, which helps maintain consistent handling. The BS-XN1/V1 set matches the NT1 geometry to ensure correct alignment and smooth rotation.

Practical installation advice

Fit bearings into clean, dry housings and check for tight seating. Use a small amount of suitable oil or grease depending on your track conditions, and recheck axle runout after installation for even wear.

Designed fit and on-track roles

Specifically matched to the XRAY NT1 range, this set is ideal for sprint races, endurance club events, and practice sessions where consistency and reduced drivetrain drag matter most.