TEAMPOWERS 64P Hard-Coated Pinion Gear 27T TP-PG6427 - Track Tuner  [TP-PG6427]

TEAMPOWERS Hard-Coated 64P Pinion Gear , 27T (TP-PG6427)
Price:
NZD$9.22
Brand:
Team Powers
Model:
TP-PG6427
Condition:
Brand New
Write a review

Fine tune performance with TEAMPOWERS 64P 27T

If you enjoy adjusting setups between runs, the TEAMPOWERS 64P 27T Pinion Gear TP-PG6427 is a straightforward upgrade to consider. Its hard-coated surface and accurate tooth profile help keep gear engagement consistent during extended sessions.

Durable coating, smooth engagement

The protective hard coat helps the gear resist pitting and scuffing under load, while tight manufacturing tolerances make for quiet, predictable meshing with the spur. That means less time babysitting gearing and more track time.

Practical fitment and use

Designed for widespread use in 1/10 scale motor setups, this 27T pinion suits drivers who switch ratios for different circuits or surface grip. Use it when you want a balanced change to speed and torque without radical gear swaps.

Is the TP-PG6427 compatible with brushless motors?

Yes, it can be used on many brushless motor setups that share the standard 64P pinion fit, but confirm spline pattern and shaft size first.

Can I reuse the pinion across different cars?

You can move it between vehicles that accept the same spline and shaft, though check mesh and wear each time you transfer it.

How do I set up the gear mesh?

Use a strip of paper between pinion and spur, tighten, then remove the paper to leave a slight clearance; recheck after a short run and retighten if needed.

Copyright © 2008-2026 rcjaz.co.nz All rights reserved