TEAMPOWERS 64P Hard-Coated Pinion Gear 36T TP-PG6436 - Precision Pinion  [TP-PG6436]

TEAMPOWERS Hard-Coated 64P Pinion Gear , 36T (TP-PG6436)
Price:
NZD$9.43
Brand:
Team Powers
Model:
TP-PG6436
Condition:
Brand New
Write a review

Precision Gear Mesh with TEAMPOWERS TP-PG6436

The TEAMPOWERS 64P Hard-Coated Pinion Gear, 36T (TP-PG6436) offers a simple way to improve drivetrain reliability. Its hardened surface and accurate tooth spacing are aimed at reducing wear and keeping runs consistent across varied track conditions.

Coating and Tooth Accuracy

The hard-coating improves resistance to abrasion while the 64P specification delivers a smooth mating with matching spur gears. Reduced friction from accurate teeth means steadier motor temperatures and cleaner power transfer.

Where to Use the 36T Pinion

This 36T pinion suits many 1/10 scale motors that accept a 64P pitch and is a good match for touring cars and light off-road models. It suits setups where you want reliable, predictable gearing without complex changes.

Fitting Notes and Maintenance

When fitting, check the mesh visually and listen for chatter during a slow run-in. Keep the gear free of grit, and replace the pinion if the tooth profile begins to deform.

Do I need a special spur gear for this pinion?

You should pair the TP-PG6436 with a spur gear that matches 64P pitch. Using a spur with the same pitch ensures proper tooth engagement and reduces premature wear.

Can I run this pinion in wet or muddy conditions?

The hard-coating helps resist corrosion and abrasion, but debris and water can still increase wear. Clean and dry the gear after wet runs to maintain longevity.

What is the best way to check gear mesh?

Fit the pinion, add a small amount of marking compound or use paper to check contact pattern, then adjust motor position until the contact is even across the tooth face.

Copyright © 2008-2026 rcjaz.co.nz All rights reserved