TEAMPOWERS TP-PG4830 30T 48P Hard-Coated Pinion  [TP-PG4830]

TEAMPOWERS Hard-Coated 48P Pinion Gear , 30T (TP-PG4830)
Price:
NZD$9.43
Brand:
Team Powers
Model:
TP-PG4830
Condition:
Brand New
Write a review

Precision Pinion for RC Motors by Team Powers

The Team Powers 48P hard-coated pinion, featuring 30 teeth, is aimed at hobby flyers and drivers who value consistent motor coupling. Its accurate tooth profile reduces backlash and keeps the pinion running true under load.

Precision Engineering

Manufactured with a hard-coated finish, this pinion resists surface wear and preserves tooth geometry over many runs. The precise cut promotes smooth engagement with the spur gear to limit uneven wear across the drivetrain.

Reduced Drag for Better Efficiency

The low friction design supports efficient power transfer, which can help control temperatures and improve throttle smoothness. It is suitable for various RC setups that require a reliable 48 pitch pinion.

What shaft sizes will this pinion fit?

Shaft fit depends on the pinion bore and spline design; check the motor shaft diameter and spline spec before fitting. Many 48P motor pinions suit common 3.17mm or 5mm shafts with the proper bore.

Can I use this pinion with high-power brushless motors?

Yes, the hard-coated finish helps durability under higher loads, but ensure correct gear mesh and cooling for high-power setups to avoid premature wear.

Any tips for setting mesh correctly?

Set a small paper shim between pinion and spur, tighten the motor, then remove the paper to achieve a snug but free-running mesh. Recheck after a short test run.

Copyright © 2008-2026 rcjaz.co.nz All rights reserved