TEAMPOWERS TP-PG4833 48P 33T Hard-Coated Pinion Performance Upgrade  [TP-PG4833]

TEAMPOWERS Hard-Coated 48P Pinion Gear , 33T (TP-PG4833)
Price:
NZD$9.22
Brand:
Team Powers
Model:
TP-PG4833
Condition:
Brand New
Write a review

Improve Drive Train Smoothness with TEAMPOWERS TP-PG4833

The TEAMPOWERS Hard-Coated 48P Pinion Gear, 33T (TP-PG4833), gives a low-friction meshing surface suited to keen RC drivers. The coating and accurate tooth form help the pinion resist wear while keeping power delivery consistent.

Built for Longer Service

Thanks to its hard-coated finish, this Team Powers pinion stands up well to repeated runs and routine maintenance. Its precise manufacturing reduces vibration and heat buildup compared with untreated pinions.

Simple Installation Tips

Mounting the TP-PG4833 is quick on compatible 1/10 scale motors; verify shaft fit and use correct threadlocker on set screws when required. Regularly inspect teeth for chipping and make small adjustments to mesh to maintain quiet operation.

Will TP-PG4833 fit my 1/10 brushless motor shaft?

It will if the shaft diameter and set screw position match the pinion. Measure your motor shaft or compare with the old pinion to confirm compatibility before fitting.

How often should I inspect the pinion?

Check the pinion after every few runs or after a heavy impact. Inspect teeth for wear or deformation and verify mesh to keep the transmission running smoothly.

Is lubrication needed on this gear?

Most hard-coated pinions perform well without heavy lubrication, but a light, appropriate gear lubricant can help reduce noise and marginally extend life in high-load situations.

Can I use this pinion on different RC types?

The TP-PG4833 suits many 1/10 scale cars and buggies that accept 48P pinions, but check overall gear clearance and drivetrain layout before swapping between vehicle types.

Copyright © 2008-2026 rcjaz.co.nz All rights reserved