TEAMPOWERS TP-PG6435 35T 64P Hard-Coated Pinion - Track Ready  [TP-PG6435]

TEAMPOWERS Hard-Coated 64P Pinion Gear , 35T (TP-PG6435)
Price:
NZD$9.43
Brand:
Team Powers
Model:
TP-PG6435
Condition:
Brand New
Write a review

Refine drivetrain response with the Team Powers 64P 35T pinion

The Team Powers Hard-Coated 64P Pinion Gear 35T is engineered to give predictable tooth engagement and reduced friction for smoother throttle inputs. It is a practical choice for model builders wanting reliable gearing behaviour.

Benefits of 64P for performance builds

Choosing a 64P pinion helps keep the gear mesh precise, which is important for high-rpm motors. The 35-tooth size provides a sensible balance between punch off the line and achievable top speed on the straights.

Built to resist routine wear

The hard-coated treatment strengthens the gear surface against chipping and abrasion, extending usable life compared to untreated pinions. Consistent tooth form preserves efficient power transfer over many running sessions.

Practical installation tips

Ensure correct axial position on the motor shaft and verify mesh with the spur gear before full-power tests. Regularly clear grit and check mounting hardware to keep the pinion performing as intended.

Can I use this pinion for brushless motors?

Yes, it works with brushless motors that accept 64P pinions, provided the shaft size and spline match the pinion's fitting.

Does the hard coat affect gear noise?

The hard-coated surface can reduce surface wear that causes rough noise over time, often leading to a quieter mesh in regular use.

Is the 35T suitable for off-road use?

A 35-tooth pinion gives a good compromise for many off-road tracks, offering usable acceleration while keeping drivetrain stress manageable.

How often should I inspect the pinion?

Check mesh and tooth condition after several runs or after running in dirty conditions; early detection of wear prevents damage to the spur.

Copyright © 2008-2026 rcjaz.co.nz All rights reserved