Tamiya 50630 TGX Bevel Gear Pair Precision Replacement  [50630]

Tamiya 50630 - TGX Bevel Pinion&Ring Gear SP-630
Price:
NZD$10.63
Brand:
Tamiya
Model:
50630
Please kindly input your name and email address, we will inform you once we have the restocking.
Or you may find similar product under the
category
Write a review

Fine-tune Your TGX Gearset

If you want to refresh or upgrade a TGX drivetrain, the Tamiya 50630 Bevel Pinion & Ring Gear set gives dependable engagement and cleaner power transfer. Designed for the TGX chassis, these gears help maintain steady torque and nimble response across surfaces.

Precision That Lasts

The 50630 components are manufactured to tight tolerances and built from durable materials to stand up to racing and weekend bashing. Their tooth profile encourages smooth mesh and lower operating noise while helping to prevent premature wear.

Engineered for Direct Replacement

The parts match TGX specifications for a simple swap that keeps factory alignment. Ideal for replacing worn gears or refreshing your drivetrain, they slot in with minimal setup required.

Do I need special tools to fit these gears?

Basic hobby tools are usually sufficient: hex drivers, a selector for pinion position, and a small gear mesh gauge if you want precise alignment. No specialised factory tools required.

Can I alter gear ratios with this set?

This pair is a direct replacement, so ratio stays the same unless you change the pinion tooth count. For ratio changes fit a different pinion while keeping the ring gear or vice versa.

What lubricant works best for bevel gears?

Use a light gear grease designed for RC differentials or a silicone-based gear lubricant to reduce friction without attracting excessive dirt.

Will dirty conditions shorten gear life?

Yes, sand and grit accelerate wear. Seal the gearbox where possible and clean gears regularly if you run in dusty or wet terrain.

Copyright © 2008-2025 rcjaz.co.nz All rights reserved