Four 1.0 inch adhesive crawler tyres made for TRX4M scale vehicles are included in this kit. The tyres use a butyl composition with a super-soft compound and come fitted with standard foam inserts plus internal reinforcement designed to reduce tears and preserve sidewall support during crawling. Size is 56mm outer diameter by 19.5mm width to suit 1.0 inch wheel profiles on the listed TRAXXAS 1/18 chassis.
Fitment focuses on a snug bead interface and an extended clamping tongue to limit tyre rotation on bead wheels. The set is supplied with a longer fixing screw and a slim clamping thickness so the tyre secures directly to compatible wheels. The foam insert steadies the tread at low speeds and the reinforced carcass should give longer service life than thin plastic tyres.
Setup tip: adjust foam stiffness to balance sidewall rigidity and contact patch; denser foam raises obstacle support while softer foam improves traction on irregular surfaces. Keep the adhesive joint clean and inspect the tyre after off-road use, renewing inserts if they deform or lose resilience.
Copyright © 2008-2026 rcjaz.co.nz All rights reserved
