Titanium M4 Wheel Nuts with Serrated Flange - HUDY 296542-B, Blue  [HSP-296542-B]

HUDY 296542-B - Titanium NUT M4 With Serrated Flange - Blue (4)
Price:
NZD$44.73
Brand:
HUDY
Model:
HSP-296542-B
Condition:
Brand New
Write a review
alt="HUDY 296542-B - Titanium NUT M4 With Serrated Flange - Blue (4)" title="HUDY 296542-B - Titanium NUT M4 With Serrated Flange - Blue (4)"

Precision Titanium Wheel Nuts M4

The HUDY 296542-B titanium M4 wheel nuts deliver precise fastening for wheel mounting where low mass and reliable thread engagement are priorities. The serrated flange grips the wheel surface to limit loosening under vibration while titanium construction keeps weight down compared with steel alternatives.

To fit, start the nut by hand on the M4 stud then finish with the correct hex driver to fully seat it. Confirm the serrated flange contacts the wheel face evenly and check hub seating before final torque. Regular inspections after running will reveal any wear or seating changes.

From a setup perspective these nuts often reduce the need for extra washers or chemical thread lockers, and their lighter mass helps overall spinning balance. Use them when consistent clamp and minimal rotating weight are desired.

Specifications

  • Item: Titanium M4 wheel nuts, serrated flange, blue finish
  • Material: Titanium
  • Model Number: HUDY 296542-B
  • Compatibility: R/C cars with M4 wheel studs

HUDY 296542-B nuts are a practical choice for tuners needing durable, light wheel retention with anti-rotation serrations, supplied as a four-piece blue set.
Remark :
Due to limited stock availability, please notice that some HUDY items may have to order from the factory and the ready time is around 8-12 weeks. Customer purchases the item is assumed to accept the waiting time which allows us to order directly from the manufacturer if the item is out of our warehouse.

Are these nuts durable enough for regular running?

Yes. Titanium offers good fatigue resistance and, when correctly seated, these nuts perform reliably under frequent use. Periodic checks are recommended to monitor wear.

Do they provide a meaningful weight saving over steel?

They are lighter than typical steel nuts and can reduce unsprung and rotational mass. The actual savings depend on the original hardware being replaced.

Is any special tool required to install them?

No special tools are needed beyond a correctly sized hex driver to seat the nut after hand-starting on the M4 stud.

Can I skip thread locker with these nuts?

Often yes. The serrated flange reduces reliance on thread locker in many setups, though users operating in very high-vibration conditions may still choose to apply a light thread locker for extra security.

Copyright © 2008-2026 rcjaz.co.nz All rights reserved