Yokomo YZ-TBS87 Titanium Turnbuckles for YZ-870C - Lightweight Set  [YZ-TBS87]

Yokomo YZ-TBS87 Titanium turnbuckle set for YZ-870C
Price:
NZD$57.89
Brand:
Yokomo
Model:
YZ-TBS87
GTIN:
639342223978
Condition:
Brand New
Write a review

Refine Your YZ-870C with Titanium Links

If you are restoring or upgrading a YZ-870C Super Dog Fighter, the Yokomo YZ-TBS87 Titanium Turnbuckle Set swaps in tougher, lighter link hardware. The pack includes six titanium turnbuckles: four at 36mm intended for upper arms and tie rods, and two at 30mm for the servo rod connections, keeping suspension geometry correct.

Performance Benefits of Titanium

Titanium brings impressive strength while cutting weight compared to standard steel parts, which can help with quicker steering and reduced inertia. The improved fatigue resistance also lowers the chance of frequent replacements after hard use.

Simple Fit for Classic Chassis

The YZ-TBS87 is designed around the YZ-870C mounting points for a clean install. Whether you are renewing an archive car or preparing a weekend racer, these turnbuckles give dependable adjustability and durability.
Remark :
Due to limited stock availability, please notice that some Yokomo items may have to order from the factory and the ready time is around 4-6 weeks. Customer purchases the item is assumed to accept the waiting time which allows us to order directly from the manufacturer if the item is out of our warehouse.

Can I use these on a different era Yokomo?

They are cut for the YZ-870C geometry, so fitting other era cars requires checking lengths and ball stud positions; do not assume direct compatibility.

Are the turnbuckles pre-threaded for ball ends?

Each piece is machined for thread engagement with standard ball studs; confirm your car uses the same ball stud size before swapping parts.

Will switching to titanium change my handling setup?

You may notice crisper steering due to lower weight and stiffer links, so check toe and camber settings after installation and fine tune radio trim if needed.

How should I look after these parts in wet conditions?

Rinse off mud and grit after wet runs, dry the parts, and apply a light corrosion-inhibiting spray to surrounding metalwork to protect threads and fittings.

Copyright © 2008-2025 rcjaz.co.nz All rights reserved