Serpent 402061 M3x42 Aluminum Trackrod - Precision Steering  [SER402061]

Serpent SER402061 Trackrod Aluminium M3x42
Price:
NZD$25.95
Brand:
Serpent
Model:
SER402061
Condition:
Brand New
Write a review

Fine Tune Steering with Serpent 402061 Trackrod

If you want crisper steering response, the Serpent 402061 Aluminum Trackrod M3x42 is a practical upgrade. Built from quality aluminium, these rods resist routine wear and keep steering predictable during frequent running.

Built to Last on the Track

This Serpent trackrod is engineered to take higher loads than standard linkages while maintaining a lightweight profile. The aluminium construction reduces flex and prolongs service life under competition and practice conditions.

Versatile Fit Across Kits

The M3x42 length and thread specification suit a broad range of RC link setups, offering flexible application. Always compare the trackrod length and thread pitch to your existing parts before installation.

How hard is this to install for a beginner?

Installation is straightforward for most hobbyists; basic hand tools and a protractor or alignment gauge are helpful to set toe and steering geometry correctly.

What servo size pairs well with this upgrade?

Any servo that fits your chassis and provides clean, precise output will work. Choose a unit with enough torque for your vehicle weight to avoid binding.

How should I maintain aluminium trackrods?

Inspect for thread wear and clean off dirt after runs. Apply light grease to moving joints if applicable and replace worn rod ends promptly.

Can this replace threaded stock parts directly?

It may replace stock rods when lengths and thread sizes match, but always verify measurements to avoid incorrect steering geometry.

Copyright © 2008-2025 rcjaz.co.nz All rights reserved