Transmitter Charging Adaptor 700mm D=5.5mm - Futaba FU6A15401  [FU6A15401]

Charging adaptor for transmitters

The Futaba FU6A15401 cable is an RC transmitter charging adaptor intended to connect a charger to transmitters that accept a 5.5mm-style plug. The 700mm lead length keeps the transmitter accessible while it charges on a bench or at the field.

This cord is compatible only with transmitters using a D=5.5mm standard charging jack; confirm your transmitter's charging inlet before use. It does not contain any voltage regulation electronics and should be used with a suitable charger according to battery and charger instructions.

To install, line up the D=5.5mm plug with the transmitter socket and push in fully, route the cable clear of the controls, and secure the lead to prevent snagging. Check the plug fit and inspect the cable for wear before each session.

Practical for field use, the adaptor permits charging without removing the transmitter pack, simplifying pre-run checks and saving time between sessions.