TRAXXAS 1/10 Slash 4x4 Precision Alloy Motor Mount SLA018A by GPM  [SLA018A]

Alloy motor mount built for Slash 4x4 setups

The SLA018A is a single-piece alloy motor mount produced as an aftermarket replacement for TRAXXAS 1/10 Slash 4x4 chassis. It holds the motor to the chassis and helps maintain correct motor-to-pinion alignment under torque. The aluminium body reduces flex seen with plastic mounts, aiding steady mesh and predictable throttle response while tuning.

Compatibility is centred on the TRAXXAS 1/10 Slash 4x4 arrangement, so confirm your motor plate hole spacing and shaft location before fitting. This part suits builders who want a firmer mount for setup work or to swap in after damage to the factory component.

Fitting is generally simple on standard Slash 4x4 cars, but take care when aligning the motor. Make sure the motor face sits parallel to the spur gear, adjust pinion mesh to a small, even backlash, and verify there is no interference with ESC leads or chassis braces. Recheck screws after a few runs to ensure nothing has shifted.

A practical aftermarket motor mount for Slash 4x4 owners aiming for a more rigid motor position during setup and tuning, supplied as a single unit by GPM SLA018A.