TRAXXAS 1/18 Latrax Rally Wheel Lock Washer Set for tighter fit - SST010/CD by GPM  [SST010/CD]

Wheel centre lock washer set

This stainless steel wheel lock washer and screw set is an aftermarket replacement intended for the centre of the wheel on TRAXXAS 1/18 Latrax Rally models. The kit swaps plain screw mounting for a countersink washer plus flat head screw to produce a more secure seating at the hub and cut down axial movement.

Contents below correspond to the wheel centre mounting hardware supplied with the kit.

• 3x3.5mm stainless steel countersink washer, 4 pcs
• Stainless steel flat head screw 3x12, 4 pcs

Fitment note: some stock screws sit inside a 3.5mm hub and leave a small gap when the screw is only 3mm. These countersink washers fill that gap so the flat head screw sits flush and stabilises the wheel under cornering and braking. Check the washer is flush with the wheel face during fitting and tighten screws evenly to maintain concentric seating. This is a straightforward upgrade to reduce wheel movement and keep consistent wheel alignment during use.