GPM TXM12160S Steel#45 CVD Shafts for TRAXXAS X-Maxx Heavy Duty Set [TXM12160S]

TRAXXAS 1/8 X-Maxx Steel#45 Front/Rear CVD Drive Shaft - 1pr - GPM TXM12160S

Price:

NZD$72.10

Brand:

GPM

Model:

TXM12160S

Not Available

Please kindly input your name and email address, we will inform you once we have the restocking.

Or you may find similar product under the

Spares / Hop-ups - Traxxas - X-MAXX

Reinforced CVD Shafts for X-Maxx Chassis

Replace factory pieces on your TRAXXAS 1/8 X-Maxx with the GPM Steel#45 Front/Rear CVD Drive Shaft to raise overall drivetrain durability. The Steel#45 material is chosen to resist repeated stress and provide a stable transfer of power during rough use.

Design Highlights

Durable Steel#45 composition to reduce wear and deformation
Specifically matched to Traxxas 1/8 X-Maxx fitment points
Improves consistency of torque delivery for better control

Packing includes

1 pair of Steel#45 CVD Drive Shafts

Original Name / Part No:

GPM TXM12160S

Compatible Models

Traxxas X-Maxx

Do these shafts require any conversion parts to install?

No additional conversion parts are normally required; they are produced to match X-Maxx mounting dimensions. Verify your servo and axle hardware are standard X-Maxx spec.

Can I reuse my existing drive cups and dogbones?

Existing cups can usually be reused if they show no excessive wear. Inspect the mating surfaces and replace any worn components to avoid premature failure.

Is special lubrication recommended?

A light, appropriate grease on splines and CV joints will help reduce wear and prevent rust. Avoid over greasing joints where debris can collect.