TRAXXAS 1/8 X-Maxx Wheel Cone Lockers 22mm Anodized Aluminium TXM005N by GPM  [TXM005N]

TRAXXAS 1/8 X-Maxx Aluminium 22mm Wheel Cone Locker - 4pcs - GPM TXM005N
Price:
NZD$36.91
Brand:
GPM
Model:
TXM005N
GTIN:
4894538036565
Condition:
Brand New
Write a review
alt="TRAXXAS 1/8 X-Maxx Aluminium 22mm Wheel Cone Locker - 4pcs - GPM TXM005N" title="TRAXXAS 1/8 X-Maxx Aluminium 22mm Wheel Cone Locker - 4pcs - GPM TXM005N"
alt="TRAXXAS 1/8 X-Maxx Aluminium 22mm Wheel Cone Locker - 4pcs - GPM TXM005N" title="TRAXXAS 1/8 X-Maxx Aluminium 22mm Wheel Cone Locker - 4pcs - GPM TXM005N"
alt="TRAXXAS 1/8 X-Maxx Aluminium 22mm Wheel Cone Locker - 4pcs - GPM TXM005N" title="TRAXXAS 1/8 X-Maxx Aluminium 22mm Wheel Cone Locker - 4pcs - GPM TXM005N"
alt="TRAXXAS 1/8 X-Maxx Aluminium 22mm Wheel Cone Locker - 4pcs - GPM TXM005N" title="TRAXXAS 1/8 X-Maxx Aluminium 22mm Wheel Cone Locker - 4pcs - GPM TXM005N"

22mm aluminium cone lockers for X-Maxx

This aluminium cone wheel locker is produced as a direct aftermarket option for TRAXXAS 1/8 X-Maxx models. The cone shape locates and compresses the wheel onto the hub, reducing movement during fast runs and rough terrain.

The set includes 4 cones sized for a 22mm wheel hex interface and finished with anodizing to help resist corrosion and wear. Installation is simple on compatible X-Maxx hubs and the cones are shaped to match common high-speed wheel profiles without hub modification.

Specifications

  • Item: Wheel Cone Locker, 22mm, 4pcs
  • Material: Aluminium
  • Model Number: TXM005N
  • Compatibility: TRAXXAS 1/8 X-Maxx

Use these cones when upgrading from plastic retainers or when you want anodized aluminium hardware that delivers consistent wheel seating and predictable preload on TRAXXAS X-Maxx vehicles.

This item is compatible with

  • TRAXXAS XMAXX
  • TRAXXAS X MAXX 8S Monster Truck

Do these cones suit standard X-Maxx wheels?

They are sized for a 22mm wheel hex interface compatible with TRAXXAS 1/8 X-Maxx hubs. Check your wheel and hub dimensions if you run non-standard hexes.

Any special installation tips?

Remove the wheel and fit the cone so it seats flush against the hub. Reinstall the wheel and tighten to the recommended torque, then recheck after a short run.

Are spacers or shims needed?

Most installations do not require extra shims; the cones are intended to match standard hub geometry. If you notice play, check for debris or minor fit differences before adding shims.

How long will the anodize last?

Anodizing gives good surface protection under normal hobby use. Avoid abrasive cleaning and salt exposure to extend appearance and fitment life.

Copyright © 2008-2026 rcjaz.co.nz All rights reserved