TRAXXAS Compatible 1/10 Stainless Tie Rod Set RUS4160S - by GPM  [RUS4160S]

Reinforced stainless tie rods for precise steering

This 21-piece kit is an aftermarket steering and linkage upgrade intended for TRAXXAS chassis, supplied under part number RUS4160S. The set focuses on front and rear upper arm turnbuckles to tighten steering geometry and increase linkage stiffness while maintaining stock mounting and lengths.

All fasteners and rod bodies are stainless steel to limit corrosion and maintain dimensions under load. Heavier wall tie rod bodies reduce bending compared with thin-wall turnbuckles, and the bidirectional threaded ends permit micro-adjustments to toe and steering trim during setup.

Kit contents: Tie Rod - 7 pcs, Stainless Steel Round Head Screws 3x16 - 10 pcs, Stainless Steel Flat Head Screws 3x16 - 2 pcs, Stainless Steel Round Head Screws 3x12 - 2 pcs. These parts suit model-level assembly and will replace OEM links when threads and lengths match your original components.

Fitment tips: verify your rod-end width and thread compatibility before installing, use an appropriate thread-locker if your build requires it, and remeasure toe after installation to confirm neutral steering. The adjustable turnbuckles also help dial in camber when used with common ball ends.

Install these stainless tie rods for a straightforward, adjustable upgrade that improves steering stability and handling on the compatible 1/10 TRAXXAS vehicles listed above.