TRAXXAS E-MAXX Front and Rear Shaft Set 14pcs EMX2037S by GPM  [EMX2037S]

Replacement front and rear shafts for E-MAXX

This 14 piece shaft kit is an aftermarket drivetrain replacement built for TRAXXAS E-MAXX machines. It pairs a 6061 T6 aluminium shaft section with #45 steel CVD heads to reduce rotating mass while concentrating wear resistance where the drives engage. Lower shaft weight reduces rotational inertia and can modestly extend battery runtime while easing load on gearbox components.

Fit details: front shafts are 85mm and rear shafts are 132mm to correspond with typical E-MAXX setups. Steel CVD ends handle wear at the dogbone or drive cup interface, while the aluminium shaft body saves weight. The set ships with the small installation hardware normally needed when swapping shafts.

Use this kit to replace tired stock parts or to adjust the trade off between strength and rotating weight on an E-MAXX. Always check spline engagement and clearances during installation to ensure secure fitment.