TRAXXAS E-REVO Upper and Lower Suspension Arms ER4567 Aluminium by GPM  [ER4567]

Front and rear aluminium suspension arms

The GPM ER4567 aluminium arm set is an aftermarket option developed for TRAXXAS E-REVO series vehicles. This matched eight piece kit supplies front and rear upper and lower arms to assist with suspension geometry tuning and reliable alignment retention.

Constructed from machined aluminium, the arms give a firmer seat for ball joints and hinge pins versus plastic alternatives. That firmer mount helps preserve pivot location under heavy loads and supports repeatable adjustments to camber, toe and roll centre using conventional setup methods.

Fitment notes: these arms align with the original hinge-pin holes and use standard fasteners on the stated TRAXXAS platforms. A hex driver and basic toolset are all that is required; verify turnbuckle settings and ride height after a short test run.

If you want aluminium arms that integrate with stock hinge-pin layouts on TRAXXAS E-REVO platforms, the 8pcs GPM ER4567 kit supplies direct-replacement arms and the necessary hardware for setup validation.