TRAXXAS Front CVD Driveshaft Upgrade 6mm Axle - FR102F by GPM  [FR102F]

Replacement front driveshafts for TRAXXAS 1/10 platforms

This front driveshaft assembly is intended for TRAXXAS 1/10 models and uses a 6061 aluminium and medium carbon steel construction with a constant velocity layout. Supplied as two matching shaft assemblies and retention pins, the set is engineered to balance rotational strength with reasonable weight for everyday RC use and drivetrain upgrades.

Installers should replace the front driveshaft parts listed in the compatibility section below and confirm axle diameter prior to fitting. The main fitment covers 6mm axle versions while several compatibility entries note 5mm axles and reference the #9080 upgrade option. Ensure the screw pins are seated correctly and check spline engagement and clearance before running.

Use this assembly as a direct replacement or as an upgrade to improve front driveline reliability and consistency on compatible TRAXXAS vehicles.

Before installation, verify axle diameter and spline fit, then fit the paired driveshafts with the supplied pins to restore or upgrade the front driveline on supported TRAXXAS models.