TRAXXAS Front Driveshafts for E-REVO and Summit Steel ER037SF by GPM  [ER037SF]

Aftermarket front drive shafts for 1/10 TRAXXAS

This 4 pcs front drive shaft set is supplied as an aftermarket replacement for RC-scale TRAXXAS chassis. Fabricated from steel #45, the shafts provide a tougher replacement for stock components on 1/10 E-REVO and Summit rigs and are intended solely for hobby use. The adjustable design helps maintain predictable driveline behaviour.

Mechanical specifics provided: adjustable length spans 75mm to 80mm to suit varied steering and suspension layouts, and steel retaining rings at each end lock the pins in place. The configuration supports routine tuning and helps keep the front driveline aligned when under load.

Included items listed with the product are: 6x8x5 aluminium collar - 1 pcs, and 2.5xM4Tx15 screw pin - 2 pcs. Following the installation instructions and checking retaining rings periodically will help prevent pin movement during normal running.

For tuners and hobbyists adjusting front driveline geometry on TRAXXAS E-REVO and Summit 1/10 vehicles, the ER037SF steel #45 set is a straightforward adjustable option focused on secure pin retention.