TRAXXAS Latrax Rally 1/18 Tie Rods Aluminium LTX160/-0.5 by GPM  [LTX160/-0.5]

Aluminium tie rod upgrade for Latrax Rally 1/18

This aluminium tie rod kit is an aftermarket steering linkage upgrade intended for TRAXXAS Latrax Rally 1/18 models, shipped as a 6pcs pack. The metal links replace soft plastic parts to give a more direct steering feel while keeping a scale appearance.

These parts sit in the steering linkage and influence toe and steering response when used in setup changes. The "-0.5 Degree" label describes the steering geometry characteristic of these pieces and is intended to be used as part of step-by-step tuning rather than a universal alignment fix.

Installation advice: swap these in for factory linkages that use the same fastener type on Latrax Rally 1/18 vehicles. Verify left and right measurements for neutral tracking, make sure threaded connections are fully engaged, and check there is no fouling with the servo or suspension travel after fitting. Inspect fasteners regularly to maintain consistent steering response.

Care and setup: consider these metal links as serviceable items, check joints for wear, and perform small adjustments to steering geometry so each change is measurable. Metal components will flex and wear differently from plastic ones, so tune accordingly for predictable handling.