TRAXXAS Latrax Rally Hub Hex +3mm LTX010D/+3MM by GPM  [LTX010D/+3MM]

Aftermarket hex adapter for Latrax Rally 1/18

This aluminium hex adapter is supplied as a 2pcs set and is intended for the TRAXXAS 1/18 Latrax Rally wheel and hub layout. It mounts on the hub to shift the brake disk and wheel outwards by +3mm for improved clearance and stance.

Use it when you need a small track increase or to stop the disk from rubbing on nearby components. The aluminium body keeps alignment consistent and holds up to repeated wheel removal and fitting.

Installation requires removing the existing hex, sliding the adapter onto the hub, and refitting the wheel so the disk and wheel align with the car geometry. As an aftermarket adapter, ensure hexes seat correctly and screws run in straight before final tightening.

In tuning terms, the +3mm change is subtle but useful for trimming clearance and refining handling on tight circuits. It is best applied as a small setup tweak rather than a large-scale modification.