TRAXXAS LaTrax SST Steering Link for 1/18 - Steel Shaft with Plastic Ends - LTX024A by GPM  [LTX024A]

Aftermarket servo tie rod for 1/18 TRAXXAS LaTrax SST cars, sold as part LTX024A. The design pairs a durable steel rod with moulded plastic end fittings to restore the connection between a servo horn and the steering knuckle.

This part is aimed at LaTrax SST variants that share the same steering linkage layout and is intended as a direct swap for the factory tie rod. Supplied as a single unit for hobby model use.

Fitting guidance: remove the servo horn or steering arm to access the link, clip the plastic ends onto the mating studs, then check steering travel and centre alignment before locking fasteners. Fine tune toe and steering to suit the driving surface.