TRAXXAS MAXX 24T Motor Gear TXMS024TS by GPM  [TXMS024TS]

24T Pinion for TRAXXAS MAXX Trucks

This aftermarket 24-tooth motor gear is supplied as a 2 pcs set and serves as a practical replacement for the TRAXXAS MAXX platform. It is produced from hardened steel #45 to resist wear where the motor pinion meets the drivetrain.

The component transmits motor torque into the drive system and is secured on the motor shaft with a 4x4 set screw. It is intended as a direct swap for worn 24T pinions to restore smooth gear engagement with the spur or gearbox input.

Fitting advice: remove the existing pinion, slide the new 24T gear onto the motor shaft, check tooth alignment, then tighten the 4x4 set screw. Recheck mesh under typical load and adjust pinion spacing if there is any binding or excessive backlash.