TRAXXAS MAXX Aluminum Steering Mount and Linkage TXMS024A by GPM  [TXMS024A]

Aluminium servo mounting solution for TRAXXAS MAXX

This aftermarket assembly replaces the stock servo mount on TRAXXAS MAXX 1/10 Monster Truck chassis to accept larger-format servos that share the 2075x-style footprint. The upgrade targets steering robustness by securing the servo, adding an aluminium tie rod and supplying a 25T aluminium servo horn to maintain accurate linkage geometry under load.

Fitment is direct-replacement for the specified MAXX platform, using the included fasteners and shims to set servo height and horn position. Aluminium components reduce movement at the servo interface when compared to moulded mounts, helping to keep steering inputs consistent during endpoint and rate tuning.

In practical tuning use, this kit supports switching to heavier, higher-torque servos by preserving horn offset and tie rod alignment so trim and dual-rate changes behave predictably while experimenting with centring and horn positions.

For hobbyists fitting a more powerful servo or chasing firmer steering feedback on the TRAXXAS MAXX, this aluminium mount and linkage kit is a simple hardware swap that preserves steering geometry during setup.