TRAXXAS MAXX Front and Rear CVD Drive Shaft Kit TXMS3F/RSA/2 by GPM  [TXMS3F/RSA/2]

Front and rear CVD assemblies for MAXX drivetrains

This GPM TXMS3F/RSA/2 kit supplies RC-scale adjustable CVD shafts intended for the TRAXXAS MAXX MONSTER TRUCK. The set swaps out traditional cross-head half-shafts for swing-style CVDs to give more consistent torque transfer when the truck is under load while keeping weight appropriate for hobby running.

The design combines hardened steel at the moving contact points with 6061-T6 aluminium bodies to balance longevity and mass. Adjustment features allow trimming of suspension geometry to reduce binding through travel, and the supplied screw pins fasten the CVD units to the existing axle interfaces.

Installation overview: fitting this kit normally involves removing the hubs and original half-shafts, fitting the CVD assemblies and securing with the included pins. After installation, check full suspension travel for smooth rotation and re-tighten any fasteners if required for secure operation.

For MAXX users wanting a serviceable, tunable driveline upgrade, this GPM CVD set offers hardened joint surfaces and aluminium bodies to extend component life and improve driveline behaviour on rough terrain.