TRAXXAS MAXX Monster Truck Front and Rear CVD Conversion TXMS123AHEX2 by GPM  [TXMS123AHEX2]

Heavy-duty CVD and hex conversion for TRAXXAS MAXX

This 20pcs conversion replaces the factory cross-pin drive parts with adjustable CVD joints and stronger hex adapters for TRAXXAS MAXX trucks. Hardened steel joint internals are combined with 6061 T6 alloy outer bodies, and axle diameter is stepped up from 6mm to 8mm to cope with increased torque while keeping unsprung weight reasonable.

The adjustable design lets you tweak driveline angles and suspension geometry; the claw-style hex adapters remove the pinhole to produce a more positive connection to the wheel hex. Track width increases by 2mm per side once fitted, which will change roll behaviour and lateral balance.

Matched 8x16x5 bearings are supplied to suit the larger axle dimension. This set is sold as an aftermarket drivetrain upgrade for TRAXXAS MAXX platforms and should be trial-fitted to your specific wheels and bearings to confirm smooth rotation and clearance.

Choose this kit when you need a tougher driveline and slightly wider stance; always verify bearing seating and driveline angles during setup to avoid premature wear.