TRAXXAS MAXX Rear Stub Axle Carriers Aluminium 7075-T6 TXMS022N by GPM  [TXMS022N]

Aluminium rear carrier overview

This aluminium rear stub axle carrier set is a scale replacement intended for use on TRAXXAS MAXX vehicles. The components are machined from 7075-T6 aluminium to hold alignment of the CVD drive shaft and to support the wheel bearing under typical off-road loads.

The carriers install into the factory rear knuckle area and act as a fixed interface for the CVD and bearing, reducing lateral movement versus original plastic parts. Fitting normally involves removing the stock carriers, installing the aluminium units, and verifying bearing seating and CVD engagement as you reassemble.

For hobbyists wanting a firmer rear end, these aluminium carriers provide a direct-fit upgrade that eases bearing inspection and improves alignment without changing the underlying geometry.