TRAXXAS MAXX Steering Linkage Plastic Ball Ends TXMS160S/BE by GPM  [TXMS160S/BE]

Replacement Ball Ends for TXMS160S Linkages

This pair of plastic ball ends is designed for RC use on TRAXXAS MAXX linkages and carries the TXMS160S designation. The components serve as direct replacements to refresh worn steering and linkage joints.

Ball ends act as the rotating interface between linkage rods and steering parts; wear here causes sloppy steering and less predictable suspension action. Swapping in fresh ball ends helps recover original steering accuracy and keeps the suspension operating as intended.

Installation is simple: remove the damaged ball end, screw the new part onto the linkage or fitting, then verify correct seating and free movement. Re-check clearances and refasten any retaining hardware to the same setting used previously.

Keep spares in your toolbox so you can replace worn ball ends quickly after a hard session.