TRAXXAS MAXX Upper Arm Support Upgrade Adjustable Stainless & Aluminium TXMW054F/RS by GPM  [TXMW054F/RS]

Upper arm support upgrade for TRAXXAS MAXX

This 14-piece supporting mount and upper arm assembly is an aftermarket hop-up tailored for TRAXXAS MAXX and WideMaxx setups. Using stainless steel and aluminium components, the kit swaps into the front or rear upper arm positions to strengthen mounting points while keeping weight down, and it provides an adjustable length method to alter wheel angle and suspension geometry for varied terrain.

Adjustment is simple: loosen the supplied fasteners and use a pin or Allen key to rotate the adjustable section, changing the effective arm length and therefore toe and camber. This gives repeatable tuning without welding or permanent modification.

Installation advice: the set fits as a direct replacement on compatible MAXX chassis configurations and includes stainless pins, screws, and washers. Standard hand tools and a hex driver are sufficient for fitting and incremental adjustments.

Deploy this kit to firm up upper mounting points and dial in suspension geometry; settings are reversible so you can iterate setups trackside or at the field.