TRAXXAS MAXX Wide Track Arm and Adjustable CVD Set TXMS100N by GPM  [TXMS100N]

Track widening arm and CVD upgrade

The GPM TXMS100N kit is a purpose-made widening and reinforcement package for TRAXXAS 1/10 4WD MAXX monster trucks. It pairs front and rear upper and lower arms with adjustable CVD drives, aluminium hex adapters and wheel locks, plus an adjustable stainless tie rod to expand track width and tune suspension geometry. The conversion pushes each wheel outboard by 20mm to improve stability while keeping driveline robustness with upgraded CVD joints and thicker axles.

Construction highlights: key aluminium pieces are made from 6061 T6 for a good strength-to-weight ratio, delrin collars and a 4mm delrin shim are supplied to eliminate play, fastening relies on pins with small retaining screws to protect threads, and several damper positions let you fine tune roll centre and ride height. Hardened steel inserts work with alloy components and axle diameter is stepped up from 6mm to 8mm for better load capacity. Bearings for the larger axles are included in the kit.

For enthusiasts wanting a wider stance, the TXMS100N supplies alloy arms, beefed CVD shafts and a full hardware set to broaden the MAXX track and let you fine tune suspension angles.