TRAXXAS MAXX WIDEMAXX 110mm CVD drive shaft and wheel lock set TXMW110FRS by GPM  [TXMW110FRS]

TRAXXAS MAXX WITH WIDEMAXX MONSTER TRUCK Hard Steel Front & Rear Extend CVD Shaft (110mm) With Aluminum Wheel Lock & Hex Claw - 36pc set - GPM TXMW110FRS
Price:
NZD$208.93
Brand:
GPM
Model:
TXMW110FRS
GTIN:
4894538360950
Please kindly input your name and email address, we will inform you once we have the restocking.
Or you may find similar product under the
category
Write a review
alt="TRAXXAS MAXX WITH WIDEMAXX MONSTER TRUCK Hard Steel Front & Rear Extend CVD Shaft (110mm) With Aluminum Wheel Lock & Hex Claw - 36pc set - GPM TXMW110FRS" title="TRAXXAS MAXX WITH WIDEMAXX MONSTER TRUCK Hard Steel Front & Rear Extend CVD Shaft (110mm) With Aluminum Wheel Lock & Hex Claw - 36pc set - GPM TXMW110FRS"

Overview of extended CVD shafts and wheel lock components

This replacement kit contains extended front and rear CVD drive shafts plus wheel locks and hex claws intended for TRAXXAS MAXX vehicles using the WIDEMAXX fit. The parts are supplied to address wear or to support drivetrain rebuilds after wide conversion work, providing a direct path to transfer torque into the wheel hubs.

The pieces prioritise correct fit and drivetrain function over styling. Fit these parts when renewing worn outdrives or when restoring proper drive geometry on a 1/10 4WD MAXX with wide MAXX parts; the kit is compatible with standard carriers and hub assemblies and does not require changes to electronics.

Packing includes

  • Drive Shaft - 4pcs
  • Diff Outdrive - 4pcs
  • Bearing 17*23*4 - 4pcs
  • Bearing 8*16*5 - 4pcs
  • Screw Shaft M4*2.5*17 - 4pcs
  • Set Screws M4*5 - 4pcs
  • Wheel Lock - 4pcs
  • Wheel Hex Claw - 4pcs
  • Steel Pin 3x15 - 4pcs

Original Name / Part No:

8996X

Compatible Models

  • TRAXXAS-1/10 4WD MAXX W/WIDE MAXX MONSTER TRUCK-89086-4

Packed as a 36 piece service set, these components simplify drivetrain repairs and part swaps on TRAXXAS MAXX WIDEMAXX monster truck conversions at 1/10 scale.

Can I use this set on a stock MAXX without wide parts?

The kit is specified for the wide MAXX layout in the compatibility box; if your vehicle is stock length, check driveshaft length and outdrive fit before attempting installation.

Which bearings are included and where do they fit?

This pack contains two bearing sizes, 17x23x4 and 8x16x5, intended for diff outdrives and shaft supports as shown in the assembly diagrams for the MAXX wide conversion.

Are steel pins and set screws included for safety?

Yes, the kit includes steel pins and M4 set screws to secure hex claws and wheel locks; ensure you tighten to recommended torque to prevent loosening.

Will installing these affect electronics cooling or layout?

No. These are mechanical drivetrain replacements and should not interfere with motor, ESC, or servo placement when fitted to the WIDEMAXX drivetrain carriers.

Copyright © 2008-2026 rcjaz.co.nz All rights reserved