TRAXXAS MAXX WIDEMAXX 110mm Extend CVD Drive Shaft TXMW110F/RS by GPM  [TXMW110F/RS]

TRAXXAS MAXX WITH WIDEMAXX MONSTER TRUCK Hard Steel Front/Rear Extend CVD Shaft (110mm) With Aluminum Wheel Lock & Hex Claw - 18pc set - GPM TXMW110F/RS
Price:
NZD$114.66
Brand:
GPM
Model:
TXMW110F/RS
GTIN:
4894538360943
Please kindly input your name and email address, we will inform you once we have the restocking.
Or you may find similar product under the
category
Write a review
alt="TRAXXAS MAXX WITH WIDEMAXX MONSTER TRUCK Hard Steel Front/Rear Extend CVD Shaft (110mm) With Aluminum Wheel Lock & Hex Claw - 18pc set - GPM TXMW110F/RS" title="TRAXXAS MAXX WITH WIDEMAXX MONSTER TRUCK Hard Steel Front/Rear Extend CVD Shaft (110mm) With Aluminum Wheel Lock & Hex Claw - 18pc set - GPM TXMW110F/RS"

110mm extended CVD assembly for TRAXXAS MAXX

This extend CVD shaft set is produced for TRAXXAS MAXX chassis that use the WIDEMAXX layout. It includes hardened 110mm steel shafts plus aluminium wheel locks and hex claws to upgrade the link between gearbox or differential and the wheel hub.

Parts are prepared for installation at either the front or rear drive locations and are intended to transmit rotational force while preserving alignment under load. The set comes with matching outdrives, bearings, pins and screws to replace the stock drive pieces.

Packing includes

  • Drive Shaft - 2pcs
  • Diff Outdrive - 2pcs
  • Bearing 17*23*4 - 2pcs
  • Bearing 8*16*5 - 2pcs
  • Screw Shaft M4*2.5*17 - 2pcs
  • Set Screws M4*5 - 2pcs
  • Wheel Lock - 2pcs
  • Wheel Hex Claw - 2pcs
  • Steel Pin 3x15 - 2pcs

Original Name / Part No:

8996X

Compatible Models

  • 1/10 4WD MAXX W/WIDE MAXX MONSTER TRUCK-89086-4

Use this kit when your MAXX WIDEMAXX needs a longer 110mm front or rear CVD; the hardened steel shafts and supplied components replace factory drive parts to secure drivetrain engagement and wheel retention.

Will these shafts fit TRAXXAS MAXX 89086-4?

They are listed for MAXX models with the WIDEMAXX geometry and specifically note compatibility with model 89086-4, but check your current shaft length and hub spacing first.

How many pieces are in the kit?

The pack contains the drive shafts and associated hardware shown under Packing includes, covering outdrives, two sizes of bearings, screw shafts, set screws, wheel locks, hex claws and steel pins.

Is special tooling required to fit these parts?

Basic tools like hex drivers, snap ring pliers and a press for bearings are helpful; the kit is designed for direct replacement but typical workshop tools make the job easier.

What materials are used in the drive items?

Primary shafts are made from hard steel for strength, with aluminium used for the wheel locks and hex claws to reduce unsprung mass.

Does the kit reference an original part number?

The original part number supplied with this kit is 8996X and the packing list above details each included item.

Copyright © 2008-2026 rcjaz.co.nz All rights reserved