This 14-piece lower arm kit fits the 1/10 TRAXXAS MAXX and Wide MAXX monster trucks and serves as a robust aftermarket replacement for both front and rear lower arms. The arms are formed from 6061-T6 aluminium and the set supplies stainless pins, screws, washers and white Delrin 4mm shims for mounting to C-hubs and suspension mounts.
Notes on fit and setup: Delrin collars are used to reduce slop at pivot points and the included rear shims address the wider rear spacing. The pin-plus-small-screw attachment secures the arms without needing long thread engagement, and several damper-position holes allow incremental damper angle changes for ride and rebound tuning.
Supplied hardware covers the standard mounting needs; install using the provided stainless pins and 3x18 and 3x8 screws and confirm motor, ESC and servo clearance prior to final tightening.
Part Location:Front or rear lower arms
Ideal when upgrading from worn plastic arms to regain firm pivot fit and keep flexible damper mounting on TRAXXAS MAXX chassis.
Copyright © 2008-2026 rcjaz.co.nz All rights reserved