TRAXXAS REVO Front/Rear Adjustable Alloy Dampers 85mm TRV085N by GPM  [TRV085N]

TRAXXAS REVO Alloy Front/Rear Adjustable Spring Dampers (85mm)with Alloy Ball Ends - 1pr set - GPM TRV085N
Price:
NZD$45.07
Brand:
GPM
Model:
TRV085N
GTIN:
4894538207293
Condition:
Brand New
Write a review

Adjustable 85mm alloy shocks for TRAXXAS Revo

This 85mm front and rear adjustable spring damper set uses aluminium construction and alloy ball ends to provide a tougher replacement for TRAXXAS REVO models. Threaded spring seats allow rapid changes to spring preload and ride height without additional modification.

Installation follows the standard TRAXXAS REVO shock mounting points. Check your model's eye-to-eye dimensions and mounting hardware to confirm the 85mm length is suitable for your chassis and suspension setup.

The pair is supplied as one set, with alloy ball ends giving a sturdy pivot interface for typical RC linkages. Tuning is best done incrementally, testing each change on your preferred track or trail to assess the effect on handling.

Specifications

  • Item: Alloy Front/Rear Adjustable Spring Dampers
  • Material: Aluminium alloy
  • Model Number: TRV085N
  • Length: 85mm
  • Quantity: 1 pr set
  • Compatibility: TRAXXAS REVO
  • Feature: Alloy ball ends

For hobbyists running TRAXXAS REVO wanting an aluminium option for preload tuning, the TRV085N pair provides durable pivot points and easy spring adjustment while keeping stock mounting geometry.

This item is compatible with

  • Traxxas REVO
  • TRAXXAS E-REVO
They are designed for TRAXXAS REVO mount patterns, but tower design can vary. Measure eye spacing and clearance on your shock towers before fitting.
If the spring seat diameter and spring length match, existing springs can usually be reused. Confirm seat fit and spring free length to ensure correct preload range.
Adjusting preload changes initial spring engagement and ride height, which influences traction and rollover tendency. Make gradual adjustments and test on the surface you normally run on.
Keep threads free of grit, check ball end wear periodically, and ensure mounting screws remain tight after initial runs to prevent loosening under load.

Copyright © 2008-2026 rcjaz.co.nz All rights reserved