TRAXXAS Revo Front/Rear Steel #45 Steering Pillow Balls ER007S by GPM  [ER007S]

Steel #45 steering pillow ball kit for TRAXXAS Revo models

This set contains four Steel #45 pillow balls intended for TRAXXAS E Revo and related Revo platforms listed below. They are produced as direct-fit replacements for front and rear steering pillow ball locations on RTR-scale models.

Fitting is routine for hobbyists familiar with steering linkages: remove the old pillow balls from the knuckles and tie-rod ends, inspect the mating surfaces for wear, then install the steel pillow balls using the existing screws or retained hardware. Compatible models require no chassis alterations.

In tuning terms, steel pillow balls improve pivot durability and may change steering feedback compared with softer compounds; they are commonly selected for rigs that see heavy use or frequent impacts. Verify free movement and recheck fastener torque after the first run.

Fit this 4-piece set as a straightforward maintenance or upgrade item to restore steering geometry and boost pivot strength; confirm fit before extended use.