TRAXXAS Revo Replacement Front Upper Link Right Side - TRV054RS by GPM  [TRV054RS]

TRAXXAS Revo /Revo 3.3 Alloy Front Upper Arm (Sandwich Design With Screws+Pins)-1pc set (For Right Side) - GPM TRV054RS
Price:
NZD$20.21
Brand:
GPM
Model:
TRV054RS
Please kindly input your name and email address, we will inform you once we have the restocking.
Or you may find similar product under the
category
Write a review

Right-hand alloy upper suspension arm for TRAXXAS Revo

This single-piece right front upper arm is built for TRAXXAS Revo and Revo 3.3 chassis. It uses an alloy sandwich layout and arrives with the mounting screws and pins needed to replace the stock right-side arm on compatible suspension configurations.

The component replaces the factory plastic upper link to recover intended suspension geometry and add a firmer mounting point. The stiffer assembly reduces flex at the steering knuckle and shock mounts so set-up adjustments hold more consistently during trail or bash sessions.

Fitting advice: install with the supplied pins and hex screws, confirm pin dimensions and hole alignment before final tightening, use the correct hex key to apply even torque, and ensure there is no interference with steering rods or shock hardware. Recheck fasteners after the first short run.

Yes, it is specified for TRAXXAS Revo and Revo 3.3 right front upper arm replacement, but verify your chassis layout against the images and measurements.
The package contains the sandwich clamp screws and mounting pins referenced in the listing; inspect the box to make sure all parts are present before installation.
Start with moderate, even torque using the correct hex driver, confirm alignment, and then re-torque after a short test run to ensure nothing has worked loose.

Copyright © 2008-2026 rcjaz.co.nz All rights reserved