TRAXXAS Revo-series Steel Front and Rear Universal Swing Shafts STRV2125 by GPM  [STRV2125]

Aftermarket universal swing shafts for Revo models

This STRV2125 kit contains a matched pair of steel front and rear universal swing shafts tailored for TRAXXAS Revo, Revo3.3 and E-REVO platforms. The set ships complete with the necessary washers and wheel hubs to replace worn components in a single service session.

As a replacement part, the shafts re-establish a firm link between suspension hubs and gearbox outputs, helping to limit axial and lateral play in the swing arms. The steel construction is selected for its resistance to wear in normal RC operation and is compatible with standard hub and washer arrangements used on the specified TRAXXAS models.

Fitting notes: this item is intended for hobbyist maintenance on scale RC vehicles and expects factory Revo-series hub bores and retaining hardware. During installation confirm hub alignment, use correct hex screw torque, and verify suspension geometry once assembled.

For model builders servicing Revo-series trucks, this steel swing shaft set offers a simple, direct-fit replacement to restore drivetrain stability and reduce maintenance time.