TRAXXAS Revo/Revo 3.3 Front Lower Arm Right-Hand Alloy Sandwich TRV055RS by GPM  [TRV055RS]

Right-hand front lower arm for Revo 3.3

This front lower arm is made for fitting to TRAXXAS Revo and Revo 3.3 machines and is supplied as a single right-hand piece. The alloy sandwich construction comes with screws and pins and is intended as a direct replacement or spare during standard maintenance and setup.

Assembly pointers:

• Confirm you have the right-hand side component before installing, as this is the right-side lower arm for Revo/Revo 3.3.
• Remove the original arm and compare mounting holes and link positions before tightening to final torque settings.
• Inspect all supplied screws and pins and apply thread locker to metal-to-metal joints when preparing for competitive or rough-surface use.

Setup and tuning notes:

• As an alloy replacement, the arm helps preserve consistent front geometry so you can fine tune toe and camber settings.
• Check steering link clearance and servo arm position after fitment, and test full suspension travel under realistic load.
• Keep this item in your spares kit for quick repairs between test runs or when swapping shock tunes.