TRAXXAS Rustler 4X4 VXL Rear Stub Axle Upgrade RUS4022N by GPM  [RUS4022N]

High Strength 7075 Rear Stub Axle Carriers

This aluminium rear stub axle carrier set is offered as an aftermarket replacement for specific TRAXXAS 1/10 4x4 platforms. Each carrier is machined from 7075 alloy to keep weight down while improving strength at the suspension junctions and axle interface.

The design seats 5x13x4 bearings in a tighter bore to reduce both axial and radial play. By limiting bearing gap the rear hubs maintain truer alignment, which helps with consistent wheel rotation during acceleration, cornering and under changing loads.

Installation notes: carriers fit as direct replacements for the models listed in the compatible box and may reuse existing fasteners and bearings where suitable. During assembly confirm bearing seating, check preload, and verify there is no interference with driveshafts or suspension links before final tightening.

Use these aluminium carriers to tighten rear bearing alignment and cut play on compatible TRAXXAS 1/10 4x4 models; they are a practical upgrade when replacing tired plastic housings.