This set of four aluminium ball ends is produced for the front and rear upper arm connections on a 1/10 TRAXXAS Rustler VXL. They act as direct replacements for worn plastic ball ends to restore a firmer link interface.
On track or trail the alloy ends reduce play where the upper arm mounts, helping the suspension keep alignment under load and allowing setup changes to be more consistent across runs. These are intended as aftermarket scale chassis parts.
Installation follows normal upper arm disassembly on the Rustler VXL; check fit with your ball studs and reuse compatible fasteners. Ensure correct thread engagement and torque to match chassis guidance when refitting components.
A straightforward upgrade for firmer upper arm link connections on the Rustler VXL, ideal for replacing worn parts or tuning for more predictable handling.
Copyright © 2008-2026 rcjaz.co.nz All rights reserved