TRAXXAS Rustler VXL Wheel Offset Hub 2mm Hex Aluminium RUS4010DX+2 by GPM  [RUS4010DX+2]

This aluminium wheel hub and 2mm hex set is built for the TRAXXAS 1/10 Rustler VXL and supplied as a 4 pcs kit. It mounts to the front and rear wheel shafts to keep steering response sharp while offering a metal finish upgrade.

Design highlights include a swirl-engraved outer ring for a tidy visual, and a thicker hub section raised from 6mm to 8mm to broaden the wheel track and enhance side-to-side stability. The claw on the hex is reshaped to clamp wheels with less slop, helping maintain a secure wheel interface under load.

Included components referenced in source information: brake disk (2pcs) and stainless steel pin 2x11 (2pcs), with manual number 1654. Supplied as a 4 pcs set for the vehicle's wheel mounting points.

Functionally this replaces the original hub and 2mm hex to adjust wheel offset and clamping characteristics. Installation is typically simple on compatible Rustler VXL hubs; after fitting, retune toe, camber and suspension where needed to suit the wider track.

Compatibility note: this product is intended for TRAXXAS 1/10 Rustler VXL use. It is not compatible with certain GPM Racing items; do not use this hub together with GPM Racing #SSLA1277RH, SSLA1280FH, SSLA1277RHA, SSLA1280FHA, SSLA1280FH21, SSLA1277RH22.