TRAXXAS Slash 4x4 +25mm Alloy Hex Adaptor SLA010/+25MM by GPM  [SLA010/+25MM]

TRAXXAS 1/10 Slash 4x4 Alloy Hex Adaptor(+25mm) - 4pcs set - GPM SLA010/+25MM
Price:
NZD$25.54
Brand:
GPM
Model:
SLA010/+25MM
GTIN:
4894538152760
Condition:
Brand New
Write a review
alt="TRAXXAS 1/10 Slash 4x4 Alloy Hex Adaptor(+25mm) - 4pcs set - GPM SLA010/+25MM" title="TRAXXAS 1/10 Slash 4x4 Alloy Hex Adaptor(+25mm) - 4pcs set - GPM SLA010/+25MM"
alt="TRAXXAS 1/10 Slash 4x4 Alloy Hex Adaptor(+25mm) - 4pcs set - GPM SLA010/+25MM" title="TRAXXAS 1/10 Slash 4x4 Alloy Hex Adaptor(+25mm) - 4pcs set - GPM SLA010/+25MM"

Hex hub adaptor for Slash 4x4

This 4pc alloy hex adaptor set fits the TRAXXAS 1/10 Slash 4x4 platform and provides a +25mm outward wheel offset per corner. These components are designed for hobbyist tuning to modify wheel placement, clearance and handling characteristics on scale vehicles.

Fitting advice: verify hex pattern compatibility with your Slash 4x4 wheels, install one wheel at a time and check for body or tyre interference, and recheck wheel fasteners after an initial short run. Because the adaptors are alloy, confirm they seat fully and do not over-torque the wheel hardware.

Practical setup notes: try the +25mm spacing to assess changes in scrub radius and cornering behaviour, watch for tyre or body rub, and combine with small suspension adjustments to refine on-track balance.

How much does each adaptor move the wheel?

Each adaptor adds 25mm to the wheel mounting point outward from the original hex, increasing overall track width by 50mm when fitted front and rear.

Will steering throw be affected?

Yes, moving wheels outward can alter steering geometry; check for changes in steering clearance and adjust tie rod length or end points if necessary.

What maintenance is needed?

Periodically check adaptors for tightness and surface wear, ensure wheel nuts remain secure, and replace any damaged parts promptly.

Copyright © 2008-2026 rcjaz.co.nz All rights reserved