TRAXXAS Slash 4x4 CVD Drive Shaft Upgrade SSLA1278FRPP by GPM  [SSLA1278FRPP]

Front and rear CVD shaft kit for Slash 4x4

This six piece kit is an RC service set for TRAXXAS 1/10 Slash 4x4 installations referencing SSLA1280FH and SSLA1277RH. Components are provided to firm up CVD joints and include the small hardware necessary for secure assembly and later maintenance.

The included items address common wear areas around the CVD so you can refresh both front and rear drives without sourcing separate tiny parts. The set suits hobbyists focused on keeping driveline operation smooth and dependable while matching the mounting points of the referenced parts.

Fitting guidance: take off the wheel and hub, remove the old retaining pins and collars, install the replacement shaft then refit pins and collars ensuring the joint rotates freely. Check for interference at full suspension droop and compression before final torqueing. Use thread-lock only where originally specified.