TRAXXAS Slash 4x4 CVD Screw Pin Set for Front and Rear SSLA1277RHP by GPM  [SSLA1277RHP]

Front and rear CVD screw pin kit for Slash 4x4

This aftermarket replacement set is made to stabilise the front and rear CVD drive shaft joints on TRAXXAS Slash 4x4 models. The pack is supplied as 2 pcs to mirror the original screw-pin arrangement used in the Slash F/R CVD yoke.

The pins hold axial and rotational position within the CVD assembly, reducing end float and helping maintain consistent driveshaft engagement under load. Fit them when the original pins are bent, worn, or show excessive play that alters driveline behaviour.

Installation is simple for those comfortable with basic disassembly: remove the affected CVD, fit the new pin in place of the worn item, then reassemble using the vehicle's original fastening method. The item is intended as a direct RC-scale replacement for the Slash F/R CVD interfaces named in the title.

Practical note: consider these pins a small but useful hop-up for driveline reliability; they do not modify gearing or motor output but help ensure steady power delivery by keeping CVD parts correctly located during hard running.