TRAXXAS SLASH 4X4 Front Hub King Pin Stainless Set SLA019AP by GPM  [SLA019AP]

Replacement stainless king pin for front C hubs

This four-pack stainless king pin kit fits the front C hubs on TRAXXAS SLASH 4X4 models and is intended for hobbyist suspension upkeep and tuning. The pins are made for straightforward replacement to recover worn pivot points without altering hub geometry.

Installation follows standard hub service steps: take off the wheel, extract the old pin, press the stainless pin into the hub bore and refit the original hardware. No specialist chassis parts are required and the set covers both front hubs for a single maintenance session.

Using new stainless pins restores reliable pivot contact and reduces steering lash, helping keep alignment and handling consistent during setup and after extended running where metal wear has developed.