TRAXXAS Slash 4x4 Hex Adaptor 6mm SLA010/6MM by GPM  [SLA010/6MM]

Aluminium hex adaptor for Slash 4x4

This item is an aftermarket wheel hex adaptor for the TRAXXAS Slash 4x4, supplied as a set of 4. The SLA010/6MM is manufactured from 6mm thick aluminium to adjust or replace the original wheel hex seating and change wheel offset.

When mounted on the axle in place of the factory hex, the adaptor gives a solid contact face between hub and wheel, helping to maintain wheel alignment during use and enabling small changes to track and inset. The aluminium construction supports stable geometry under typical hobby use.

Use this adaptor for simple mechanical tuning of wheel position or to restore correct wheel fit where the stock hex is worn. The part is intended for hobby RC use and is specified for the Slash 4x4 chassis named above.