TRAXXAS Slash 4x4 Low-CG Aluminium Adapter and 56T Spur with 15T Pinion SLA155615TLG by GPM  [SLA155615TLG]

Aluminium adapter matched to hardened steel spur and pinion

This set supplies an aluminium low-mass gear adapter matched to hardened steel 32-pitch spur and motor gears for RC-scale use on TRAXXAS Slash chassis. The pair replaces the standard adapter and gears for the listed version and is intended to stabilise gear engagement between the motor and drivetrain.

Core specification highlights the 56T steel spur and a fixed 15T motor gear for 32-pitch systems, with an aluminium adapter that sets motor position and maintains correct mesh. The metal gears are heat-treated steel to better withstand wear in typical off-road and tuned driving.

When tuning, swapping the motor gear changes the drive ratio; common pinion sizes paired with a 56T spur run from 13T to 20T, enabling builders to fine-tune acceleration versus top speed.

• Matched 56T steel spur and 15T motor gear for 32-pitch setups.
• Low-profile aluminium adapter to locate motor for Low-CG Slash 4x4 installations.
• Hardened steel construction for the spur and pinion to reduce wear.

Fitment tips: set correct gear mesh and axial alignment, retain stock fasteners where they fit, and measure pinion clearance to prevent binding. This part is intended as a replacement or tuning upgrade for the model version listed below.

Use this kit to add a hardened 56T spur and a pre-set 15T motor gear mounted on an aluminium adapter when you want precise mesh and consistent drivetrain response on the specified Slash variant.