TRAXXAS Slash 4x4 Turnbuckle Set for Toe Adjustment SSLA160ST by GPM  [SSLA160ST]

Turnbuckle upgrade for Slash 4x4

This 3pcs set of spring steel turnbuckles with alloy ball ends is supplied for TRAXXAS Slash 4x4 1/10 scale vehicles as a reliable replacement or aftermarket upgrade for steering and suspension linkages. Spring steel shafts improve straightening resistance while alloy ball ends maintain consistent articulation in the ball sockets.

To install, remove the old turnbuckle, match left and right thread directions, then screw the replacement into the existing ball cups until the desired length and steering geometry are reached. Because measurements are model-specific, preserve factory references and tweak adjustments in small steps to keep alignment correct.

These turnbuckles are useful for tuning since they allow repeatable length adjustments for toe and steering angle and present a sturdier joint that stands up better to impacts. Use them to refresh worn ball ends or to lock in handling changes during setup sessions.

A straightforward aftermarket option to keep steering geometry precise on Slash 4x4 rigs, provided as three pieces for selective replacement.